Repeat steps 1-6 until your surface is smooth.Wait for first coat to dry and scrape any high spots or blobs.There is something called a magic trowel that works really well, it’s like a squeege. Immediately remove with a large bladed trowel or drywall knife.Take a large nap paint roller and roll a section heavy like paint.Buy an all purpose drywall compound, add water and mix it to a pancake batter consistency.This will knock down any dirt nibs or junk in the paint. Take a pole sander with the grit of your choice and lightly sand the walls.I’ve done this on my old condo that had years of terrible paint jobs. Much of the condo doesn't have baseboards, I think to embrace an industrial look (or save money/time), but maybe baseboards would be the easiest way to "fix" this? This is the only wall that has this issue.Is this just peeling paint? How do I prep this if I skim coat and prevent it from happening in the future? Unlike in #1, this isn't bubbly, it's hardened and solid. Really not sure what is going on here.Is this a crack in the skim coat? There are a few of these around, mostly near doors and corners.Is this just a drywall seam? It looks like there was a drywall repair here as well.I'm wondering if this is from water damage from the unit above me that created a bubble either in the drywall or the layers of paint? Is that a thing?.For all of them, I'd love to know what's going on and how to fix them if possible. I've posted pics here, and I've tried to show them from a few angles to provide context. To complicate things, there are a couple of spots where there are issues with the drywall that I'm not sure if/how to fix before doing any skim coating. General advice on how to or whether it's worth doing is also welcome.Does anyone have experience with this going poorly/regretting it? The texture on the walls looks dated to me, but I'd hate to go through the effort of skim coating only to have it look worse in the end.Just how bad is this part and what precautions should do I need to take to protect items in my home? Do you recommend boxing things up and removing them completely, or will covering them in plastic suffice? Everyone says the sanding at the end is the messiest part because the dust gets everywhere and sticks around forever.The walls are painted, and I see conflicting advice on whether to prime them before skim coating.What type/brand of mud to use as a beginner, to get the best result.I've seen a lot of tutorials and videos on the process and I think I get the general idea of how to do it, but I have some questions/concerns: It seems like it takes a lot of time and work to do it yourself, but could be worth it if you prefer a smooth finish. I'm contemplating skim coating over the orange peel and knockdown texture I have on the walls (and ceilings in some rooms) to get a smooth finish, so I've been doing a bit of research. I basically have no idea what I'm doing, so tyia :) I have some questions about skim coating and drywall issues in my 1970's highrise condo in Colorado, and I'm hoping to get some advice.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |